18m 40s | 2609 view | 31 rating

http://coastlinerobotics.com/ A complete analysis and build log of the frame designed and developed by the Coastline Robotics engineering team. 00:19 - Introduction 02:17 - Design explanation 03:00 - Components 03:58 - Build log 04:31 - Installing the PDB 04:54 - Installing the ESC's 06:00 - Motor installation 06:43 - Installing the 5V output 07:03 - Powering the FPV transmitter 07:30 - Installing the battery voltage input cable 07:45 - Flight controller pins installation suggestion 08:02 - Placing the 3D printed skirt 08:36 - Checking the electrical system outputs 08:58 - Installation of the flight controller 09:48 - Installation of the FPV antenna extension cable 10:40 - Preparing the RC receiver 12:35 - Preparing the FPV camera connection 12:52 - Placing the top plate 14:06 - Installing the camera pod 14:50 - Installing the FPV camera 15:10 - Installing the camera pod standoffs 15:24 - Installing the RC receiver antennas 16:16 - Installing the LED lights 16:43 - Installing the Propellers 17:16 - Installing the HD camera 17:31 - Testing the Banshee 18:11 - Outro Components: Frame : http://bit.ly/2asll1Z Flight Controller: http://bit.ly/2acDqCc Motors: http://bit.ly/2acDulv ESC's: http://bit.ly/2aXaVp7 PDB: http://bit.ly/2aLVXDv RC Receiver: http://bit.ly/2au6ZLN FPV transmitter: http://bit.ly/2aGqeFz FPV camera: http://bit.ly/2aJCIgw FPV antenna: http://bit.ly/2asmHtG FPV antenna extension cable: http://bit.ly/2au7vJz Nylon Standoffs to mount flight controller: http://bit.ly/2aJPlZh Radio transmitter: http://bit.ly/2ape7Iv Battery: http://bit.ly/2acEruc Led lights: http://bit.ly/2amksq4 contact@coastlinerobotics.com