Machines | Cat 992C Cold Start

videos | at work | information | view | construction

1. what a ass, lets starter cool for whole 30 seconds and he is right back on it what a ass, poor slob that buys this needs a starter
2. is this place the old Kelbe Bros. in Wauwatosa Wis? on Silver Spring Dr.????
3. This is a case where a bit of starting fluid would make a huge difference. All that grey exhaust smoke means that unburned fuel is soaking piston tops and especially exhaust valve stems. Many of these engines have been damaged by exhaust valves sticking in their guides after the unburned fuel on valve stems turned into varnish, when the engine warmed up. Use block and oil pan heaters, when starting in cold conditions, use enough starting fluid to make sure all cylinders are firing.
4. either...spray it in
5. they need to start all of them up one at a time
6. Sounds like a MTU engine like what are used in HST trains
7. don't let it warm up at all just get in there and pinner buds
8. This is why I'll never buy anything from a Ritchie bros sale...
9. Give'r a sniff
10. Nice video😄
11. Ease up on that started dude.@ or 3 runs will make it go and not have to re-build a 50 MT.Big bucks.
12. Das tut mir ja in der Seele weh was Ihr mit dem Motor macht
13. 3412? if so they are some cold natured bitches haha
14. I no it takes a lot of turning the engine over but by the time it acutely starts there would be heat in the engine because of all the puffing it done
15. poor effn starter!
16. ma dobry rozrusznik
17. nice battery
18. WHy me Why me why ME why Me why me?!
19. Machines that cost so much should have something that my old half-cheap BMW has. It is called diesel fuel heater. Really? Like 800$ is too much... dohh
20. вот она СРАНАЯ американская техника,у них все ГОВНО!